Skip to content

Xueming Yu

Good to Best

Menu
  • Home
  • About
  • Contact

Category: 3D Print

Posted onAugust 7, 2013June 11, 20203D Print

3D printer nozzle diameter comparison: 0.4mm vs. 0.35mm vs. many others

by Xueming2 Comments on 3D printer nozzle diameter comparison: 0.4mm vs. 0.35mm vs. many others

Owning 3D printers with different nozzle diameters, I am able to give some first-hand experience on their advantage and disadvantage. Hope these could be helpful. FYI, my 0.4mm printer nozzle…

Read More
Posted onApril 24, 2013June 11, 20203D Print

How to 3D print peel-able supportive raft/base/platform with slic3r

by Xueming21 Comments on How to 3D print peel-able supportive raft/base/platform with slic3r

First of all, let’s check out how easy and sweet it is to remove the supportive raft from your 3D print. All you need to do is just to follow…

Read More
Posted onApril 22, 2013June 11, 20203D Print

Making a heated build platform (HBP) for Type A Machine, or any 3D Printer

by Xueming9 Comments on Making a heated build platform (HBP) for Type A Machine, or any 3D Printer

First of all, let’s see the video of the heated print bed in action! This table is built for Type A Machine 3D printer, but it should works for all…

Read More

Gallery

Categories

  • 3D Print
  • Computers and Internet
  • DIY Cantilever Sliding Gate
  • Electronics
  • Embedded
  • Handyman
  • Hobby
  • Laser cut
  • Mechanics
  • Others

Recent Posts

  • Understand dsPIC33/PIC24 DMA Data Transfer Modes: One-Shot vs. Continuous vs. Repeated vs. Non-repeated
  • Altium Desinger Adding Net Name to Hidden Pin
  • OpenRISC(1): First run OpenRISC on de0-nano board
  • Notes on PHP: Restart apache won’t reset php session
  • Drive computer vision camera (Point Grey) on single-board computer (Banana Pi)
  • How to rework small surface mount LED
  • Teardown of Ricoh Theta 360 Degree Spherical Panorama Camera

Recent Comments

  • DIY, how to build your own cantilever sliding gate (8) – Mount the fencing board! – Xueming Yu on DIY, how to build your own cantilever sliding gate (7) – Install the gate opener
  • DIY, how to build your own cantilever sliding gate (1) – Make a plan – Xueming Yu on DIY, how to build your own cantilever sliding gate (5) – Weld the galvanized pipes into a gate frame
  • DIY, how to build your own cantilever sliding gate (8) – Mount the fencing board! – Xueming Yu on DIY, how to build your own cantilever sliding gate (3) – Set the post with 4″ Dia. galvanized pipe by only one man
  • Designing bootloader for Microchip dsPIC33E/PIC24E micro-controller(3) – Xueming Yu on Designing bootloader for Microchip dsPIC33E/PIC24E micro-controller (2)
  • Decode IR signal of Panasonic HD camcorder HC-X900M remote controller – Xueming Yu on Synchronize multiple Canon Rebel T4i video shooting with reverse-engineered RC-6 protocol
Copyright Xueming Yu. All Rights Reserved.
Copyright © 2022 Xueming Yu ⋅ All Right Reserved