Skip to content

Xueming Yu

Good to Best

Menu
  • Home
  • About
  • Contact

Tag: Altium Designer

Posted onJune 9, 2020June 9, 2020Electronics

Altium Desinger Adding Net Name to Hidden Pin

by XuemingLeave a comment on Altium Desinger Adding Net Name to Hidden Pin

It used to be pretty straight forward to assign a net to a hidden pin of a component using the right-click property menus. However, this function has been relocated to…

Read More
Posted onDecember 25, 2013June 11, 2020Electronics

Defining copper to drill hole clearance rule in Altium Designer

by Xueming7 Comments on Defining copper to drill hole clearance rule in Altium Designer

The “copper to drill hole” distance is an important rule for circuit board design, just like the “copper to copper” clearance. A PCB manufacturer usually announce their minimum allowable clearance…

Read More
Posted onApril 4, 2013Electronics

Tips for gerber export in Altium Designer

by Xueming1 Comment on Tips for gerber export in Altium Designer

I sent out a new circuit board design to a PCB fab house last week, but was put on hold multiple times for the reason of “insufficient copper to copper…

Read More

Gallery

Categories

  • 3D Print
  • Computers and Internet
  • DIY Cantilever Sliding Gate
  • Electronics
  • Embedded
  • Handyman
  • Hobby
  • Laser cut
  • Mechanics
  • Others

Recent Posts

  • Understand dsPIC33/PIC24 DMA Data Transfer Modes: One-Shot vs. Continuous vs. Repeated vs. Non-repeated
  • Altium Desinger Adding Net Name to Hidden Pin
  • OpenRISC(1): First run OpenRISC on de0-nano board
  • Notes on PHP: Restart apache won’t reset php session
  • Drive computer vision camera (Point Grey) on single-board computer (Banana Pi)
  • How to rework small surface mount LED
  • Teardown of Ricoh Theta 360 Degree Spherical Panorama Camera

Recent Comments

  • DIY, how to build your own cantilever sliding gate (8) – Mount the fencing board! – Xueming Yu on DIY, how to build your own cantilever sliding gate (7) – Install the gate opener
  • DIY, how to build your own cantilever sliding gate (1) – Make a plan – Xueming Yu on DIY, how to build your own cantilever sliding gate (5) – Weld the galvanized pipes into a gate frame
  • DIY, how to build your own cantilever sliding gate (8) – Mount the fencing board! – Xueming Yu on DIY, how to build your own cantilever sliding gate (3) – Set the post with 4″ Dia. galvanized pipe by only one man
  • Designing bootloader for Microchip dsPIC33E/PIC24E micro-controller(3) – Xueming Yu on Designing bootloader for Microchip dsPIC33E/PIC24E micro-controller (2)
  • Decode IR signal of Panasonic HD camcorder HC-X900M remote controller – Xueming Yu on Synchronize multiple Canon Rebel T4i video shooting with reverse-engineered RC-6 protocol
Copyright Xueming Yu. All Rights Reserved.
Copyright © 2021 Xueming Yu ⋅ All Right Reserved